TylerAdamson
Well-known member
I'm attempting to get 934 back on the roads and out of the shop. Over the past few weeks I've swapped out the 4 lugs in favor of the 5 lugs and the 3 bolt rear in favor of the 4 bolt rear. I went to finalize my SS brake lines today and one of the wheel studs has come out of the hub and is spinning freely in the hub which is preventing me from removing the lug nut and removing the rim. Initially I was going to attempt to press the stud back into the hub, but I have no means of getting to the back of the stud. Has anyone else ran into this issue and if so what was your resolution? I'm wanting to get this resolved tomorrow and have the car finished by the end of this coming week.