P/S switch/sensor on top of resevior cap

I could really use a picture of where the wires for this guy integrate into a main harness. My wires are severed on the harness side the black male/female connectors and I can't seem to find where on the harness the wires might be. TIA /ubbthreads/images/graemlins/smile.gif

 

[makedollarz]

I can get you a picture of that tonight if you still need it. Im going to swap to a 1g reservoir in since I removed the 4ws a while back.

Since the wires are cut, is it triggering your dummy light in the dash? Im not sure what to do becuase the cap from the 4ws doesn't fit the cap from the 1g reservoir that I'm trying to swap it with.

 

[conquesttsi]

If you go with a 1g setup you have to ditch the dummy light.

 

Yeah, i'd love a picture. That area of the bay is a little crowded but I'm kind of at a loss as to why I can't find the wires. Possibly a PO hid them? Why not solder them back together lol. No dummy light on the dash though.

 

[makedollarz]

I'll be working on the car late tonight. I'll grab a few for you. It's pretty hard to tell where they need to go cause they connect to a big wiring haness that runs along the fender, but me snap a few. You Could prob figure it out from the wire colors.