birdman24
Well-known member
So my motor has developed a rod knock and since it already had a few other problems I figured it would be better to just rebuild it. I have never rebuilt a motor so this is a learning experience. I want to run forged .20 over 9:1 Wiseco, Eagle H-beams, Complete oem gasket set, Arp everything, Acl rod and main bearings. I've read that with a 9:1 compression detonation will occur with high boost, does anyone have any suggestions for ways to combat the detonation?
Does this set up look okay? Am I missing anything?
I currently have a E3 16g, chipped ecu, 550's, upgraded fuel pump, full 3in exhaust, safc, and 2g mani. I'm working on getting an afpr, 660's, c.o.p, and Ecmlink v3. I'm looking to make 400 to 500 whp, is this set up over board for the numbers that I would like to make? I'm considering making a tubular manifold with an external gate and buying an hx-35 or 20g but that is not in the near future. Any help is greatly appreciated.
Thank you,
Terence
Does this set up look okay? Am I missing anything?
I currently have a E3 16g, chipped ecu, 550's, upgraded fuel pump, full 3in exhaust, safc, and 2g mani. I'm working on getting an afpr, 660's, c.o.p, and Ecmlink v3. I'm looking to make 400 to 500 whp, is this set up over board for the numbers that I would like to make? I'm considering making a tubular manifold with an external gate and buying an hx-35 or 20g but that is not in the near future. Any help is greatly appreciated.
Thank you,
Terence
Last edited: